Remember, 1/2in x 18in isn't quite as common, so you'd definitely have to order online instead of finding it in stores. You can pick up a pack of 10 of these belts for about 12$. cabinetmakers/woodworkers/renovators/DIYers/furniture & autobody repair, refinishing or restoration. I would say that this tool is great for anyone who needs to sand in tight spaces, i.e. I keep finding things to do with this, and it makes it kind of fun. Also, turns out it's good for cleaning up after a hole saw, as well. It has a rubberized handle/motor mount that you use for fine detail work. You can keep it upright so you can set it next to you and just snatch it up, ready to go. All of my current sanders are corded and I just prefer the agility of cordless tools. I'm doing a lot of adjoining cuts and finishing off with a pullsaw, this thing makes cleaning up those corners a breeze. I'm excited because this I can use for furniture refinishing and woodworking. They have tiny contours that won't fit any traditional sander in. The tool you didn't think you needed but were TOTALLY WRONG! The wife is excited to use this to clean off the old paint drips from the door trim. Thank you RYOBI and thank you too Home Depot! They're solid as a rock and smooth as a baby's behind. Once I had this baby in my hands, I was able to complete the project within a few hours. I searched Home Depot's website and instantly found what was needed. The issue was that the space between the spindles was far too narrow for a conventional sander. But the only problem with that is sanding off the excess after it all dried. The only solution was to use a 2-part epoxy system. I was fortunate enough to find someone who could fabricate a new one and another person to install it but I was still left with a bunch of nasty old treads, risers, and stringers. The entire right side of the railing was even missing (handrail and spindles). It was a total mess from one end to the other. A few weeks ago, I decided to take on a huge project. Not only was this the perfect tool for my project, but it was also the only one. Time to sand them smooth, stain and/or polyurethane topcoat. Without pics of the legs, I'm thinking use a hand held rotary tool with a ball end burr to open up the cracks then fill them with thin layers of wood filler. Once you've got it down to bare wood I'd hand sand it with a grit recommended for the topcoats. I'd test if first on a spot that doesn't show to judge the reaction with it and the topcoat. If it was mine and wanted to do it myself, I'd use a chemical stripper, something water based especially if it's veneer, you don't want to lift the glue that attaches it. You may choose to have them strip it then you can refinish it. If you can disassemble it, take plenty of pics and mark which legs go where then bring all the pieces to a shop for their opinion and/or estimate. If the table has sentimental value you'd be best leaving it to the pros. Start by looking up some YouTube videos about it to see if you have the skill to do it. A: I'm not a professional furniture restorer but here's some tips.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |